reTerminal D1001

Introduction

The project provides basic SDK for the reTerminal D1001, as well as the examples for getting started. It is based on the ESP-IDF.

Getting Started

Install ESP IDF

Follow instructions in this guide ESP-IDF - Get Started to setup the built toolchain. Currently we're using the latest version v5.4.2.

Clone and Setup the Repository

1. Clone our repository.

   git clone https://github.com/Seeed-Studio/reTerminal-D1001

2. Go to reTerminal-D1001 folder.

   cd reTerminal-D1001

Build and Run Examples

1. Go to examples folder and list all available examples.

   cd examples && \
   ls

2. Choose a <demo> and enter its folder.

   cd '<demo>'

3. Generate build config using ESP-IDF.

   # set build target
   idf.py set-target esp32p4

4. Build the demo firmware.

   idf.py build

5. Flash the demo firmware to device and Run.

   To flash (the target serial port may vary depend on your operating system, please replace /dev/ttyACM0 with your device serial port).

   idf.py --port /dev/ttyACM0 flash
   

   Monitor the serial output.

   idf.py --port /dev/ttyACM0 monitor
   

Tip

• Use Ctrl+] to exit monitor.

• The previous two commands can be combined.

  idf.py --port /dev/ttyACM0 flash monitor

Contributing

• If you find any issue in using these examples, or wish to submit an enhancement request, please use the raise a Issue or submit a Pull Request.

License

This project is released under the Apache 2.0 license.