This repo implements the FasterEdge framework on the Feeling Technology PMS150C in minimal form. The PMS150C is a PDK14 core with 1KW OTP program, 64B RAM, 6 pins, no UART — one of the smallest MCUs. Following the "register-only base control" design, it is trimmed to GPIO control + chip info.
- ✅ pm_ide/ (official Feeling PM-IDE) + platformio_ide/ (Free-PDK open-source toolchain) dual editions
- ✅ Register-level GPIO control (direct IOSTA/PA)
- ✅ Minimal command set fitting 1KW OTP / 64B RAM limit
| Name | Type | Commands/Function | Description |
|---|---|---|---|
GpioAbility |
Ability | mode / write / read |
PA0 output (LED), PA1 input (button), register-level |
ChipData |
Data | info |
chip info (fixed string) |
Example (main loop): button PA1 pressed → light PA0, else off.
| Capability | Reason |
|---|---|
| Base/Role/Time/OneKey/Serial/Modbus/RegAbility | No UART (no serial command channel), RAM only 64B, OTP only 1KW |
| ConfigData | No EEPROM/Flash to persist |
| All network abilities | PMS150C has no network |
MCU-PMS150C/
├── pm_ide/ # official Feeling PM-IDE
│ ├── pms150c.h # register map / pin constants
│ ├── fe_port.h # porting layer (GPIO / info)
│ └── src/main.c # register-level GPIO demo
└── platformio_ide/ # PlatformIO + free-pdk (open-source)
├── platformio.ini # board = padauk-pms150c
└── src/main.asm # PDK assembly (PA0 out / PA1 in)
PMS150C has no UART; both editions demo register-level GPIO control and do not provide a serial command interpreter.
- pm_ide edition: PM-IDE → New Project → chip PMS150C → add
src/main.c(or Mini-C/assembly) → Build → OTP Writer - platformio_ide edition:
cd platformio_ide && pio run -t upload(free-pdk platform) - Wiring: PA0 → LED (series resistor), PA1 → button
| Aspect | ESP32/ESP8266 | PMS150C |
|---|---|---|
| Architecture | Xtensa 32-bit | PDK14 (14-bit instructions) |
| Program / RAM | KB~MB | 1KW OTP / 64B |
| Peripherals | WiFi/UART/ADC etc | GPIO + timer only |
| Serial | Yes | No |
| Storage | NVS / Flash | OTP one-time programmable |
PMS150C, like PIC10F200, is ultra-low-end and only does register-level GPIO base control. For the full capability set, switch to MCU-C51 / MCU-CH32V003 and other larger-resource platforms.
- FasterEdge MCU - C51: 8-bit 8051 (full capabilities)
- FasterEdge MCU - PIC10F200: also ultra-low-end
- FasterEdge MCU - Arduino Uno R3: 8-bit AVR
- FasterEdge: framework main repo